Brushless Motor Controller DC 12-36V 500W PWM Driver Board
Efficient brushless motor controller with adjustable resistance and capacitance for optimal performance.
- Protection: Overload protection, locked-rotor protection, over-current protection
- Analog voltage speed regulation: 0-5V
- Operating temperature: -40 ~ +85
- Drive power: 500W (related working voltage)
- Size: 62 x 42.5 x 17 mm
- Weight: 26 gm
- Speed control function: Voltage speed regulation or single chip microcomputer control: PWM speed regulation
Top Features:
- Overload, locked-rotor, and over-current protection
- Analog voltage speed regulation from 0-5V
- 500W drive power
- Compact size of 62 x 42.5 x 17 mm
Pin Connection:
5V- Driver board internal output voltage
Signal- Motor speed pulse signal output port, 5V pulse signal
Control port: Z/F Rotating direction control ports. Connect 5V high level or no connect is Forward direction, connect 0 V low level or connect to GND is a reverse direction. VR-Speed control port. Analog voltage linear speed regulation 0.1v -5V, The input resistance is 20K Ohm, connect with GND when input PWM speed regulation, PWM frequency:1-20KHZ; Duty cycle 0-100% GND Used for Drive board internal control.
Power port: MA-motor phase AMB- motor phase BMC- motor phase CGND-DC-VCC-DC +
Application notes: Confirm that the voltage and power parameters of the motor do not exceed the range of the driver board as specified. The JYQD-V6.3E2 driver board is a bare board without housing and heatsink. If the power of the motor is below 60W, it does not need to add a heatsink, It only needs to ensure normal ventilation and wall insulation. If the power of the motor is more than 100W, it must add a heatsink. Please take note that JYQD-V6.3E2 driver board has no anti-reverse connection protection, it will permanently damage the driver board if reversed polarity connection. The 5V output port on the driver board prohibits connect an external device. It is only applicable to the external potentiometer and switch of the board for speed regulation and reversal. The Signal terminal on the JYQD-V6.3E2 driver board is the motor speed pulse output signal (push-pull output), and the maximum output current is less than 5mA.
Package Includes: 1 x Brushless Motor Controller DC 12-36V 500W PWM Driver Board
- Voltage Range(V): 12-36
- Current handling Capacity(A): 15
- Power handling Capacity(W): 500
- Length (mm): 63
- Width (mm): 42.5
- Height (mm): 17
- Weight (gm): 30
* Images are for illustration only; actual product may vary.