1 inch Brass Water Flow Sensor
Measure liquid flow easily with this high-quality brass water flow sensor.
- Water quality requirement: Drinking water health standards, 0~80?
- Flow range: 4~45 Liter/Min
- Voltage/electric current: DC 4.5 – 18 Volt, ±15mA
- Insulation resistance: >100M?
- Withstand hydraulic pressure: ?1.75 MPa
- Electrical strength: AC500V, 50HZ
- Output level: Rated voltage DC 5 Volt, high level ?4.5 Volt, low level ?0.5 Volt
- Pulse duty cycle: 50%
Top Features:
- Brass body for durability
- 3 pin JST connector for easy setup
- Flow range of 4~45 Liter/Min
- Simple rotating wheel design
This 1 inch water flow sensor is commonly used in various vending machines and industrial applications. It is connected in line with the liquid to measure the flow rate accurately. The sensor features a rotating wheel with a magnet, and a hall effect sensor measures the rotations to provide pulse output signals. By counting the pulses, you can calculate the flow rate and dispensed liquid amount efficiently.
The sensor comes with a 3 pin JST connector where Red is for Vcc (5 to 18 volts), Black is for Ground, and Yellow is for Pulse Output signal.
Applications:
- Thermostatic water heater
- Water purifier
- Water dispenser
- Smart card equipment
Note: When magnetic material is close to the sensor, its characteristics may vary. To avoid particle debris, install the sensor after a filter. Ensure the sensor installation avoids strong vibration and shaking to maintain measurement accuracy.
* Images are for illustration only; actual product may vary.